Skip to main content
Skip table of contents

X2 SQM Price List

In the packQ packaging editor, the customer gets the possibility to create packaging according to his own requirements. The size of the packaging and thus the amount of material used can vary.
The square meter price list allows you to define the prices for these products. Depending on the amount of material used by the customer, the price list in the editor adjusts itself.

The areas for which a price scale is to apply are always entered up to a defined measure (m²). Thus, it is possible to map the price jumps that result from the use of the more (or less) utility.

With "Create" you add a new square meter price scale to your list.

It is best to enter a name that aptly describes the price scale. Under "Square meters" you can then specify the area to which the price scale should apply. Then determine the price scale that will be used for the specified area.

Name

Name of the price list. This is not communicated to the frontend

Square meter

Here you enter the area. Dot serves as decimal separator

Stores

Here you decide whether the fixed price list is only visible for a specific store view within the data center.

Tier prices

Here you enter the number of pieces and upwards as well as the corresponding price.

Example:

Up to a package size of 0.1685m², a 4-package benefit can be realized on the printed sheet, whereby a favorable graduated price takes effect. If this size is exceeded, only a 2-up panel is possible. The price list defined by you for this size now applies, which increases the price per packaging.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.